Wilson Banner

Center Loaded Antennas
Short Load Adapter
Short Load Adapter Photo 1
Yellow Line

Photo Of Short Load
   
Photo Of Short Load

The Wilson Short Load

Have a height limitation?    Can't get into the garage?    The overpass is too low?
If you have this problem and you need a short antenna, but want the maximum performance that the height limitation puts on you, then the Wilson Short Load is the answer!

Designed for maximum efficiency, it is only 3ft short and replaces the 62" whip that is standard for the Wilson 1000 and the Wilson 5000.

It will also replace the 49" whip that is standard on the Trucker 2000 & 5000 for those drivers concerned about their height restrictions.

The band width will still be wide enough for most uses - 1-1.2 MHz, and the power handling is a strong 500 watts.

The Short Load adapts to the Wilson 500 and all models of the Wilson 1000, 5000, Trucker 2000 and the Trucker 5000.

The perfect solution for those height problems.

Easy to Tune and Install
  1. Loosen set screws in chrome mast of antenna and remove the existing antenna's whip.

  2.  Remove the vinyl cap from the bottom ( 11" length ) portion of the short load.

  3.  Insert the bottom portion into the mast.

  4.  Perform SWR test to determine reading.

  5.  If necessary to trim antenna, remove vinyl cap from the top ( 26" length ) portion of the short load.

  6. Cut to lowest SWR from the top whip, using bolt cutters or a hacksaw.

  7. When completed, replace top vinyl cap.

 Short Load Drawing
NOTE:
  1. Do not cut the bottom whip - always trim at top whip.
  2. The top whip is supplied longer than necessary for use on channel 1-40, and must be trimmed.

Yellow Line


Wilson Antenna Company
A Division of Barjan, LLC
US Flag
Made in the USA
Email
E-Mail
Wilson